To determine the size of the end windows,
I used pieces of heavy weight paper and cut to fit. Trial and
error. Here is an end window and its paper piece.
In order to get the top started, I
tacked the white styrene to the room and then glued the two side pieces
to the white bottom pieces and the top. Does that make sense?
I'm not sure, even I'm confused now.
Same deal different angle.
In order to glue the rest of the windows
down etc., I put the whole assembly on wax paper and then added lots of
glue.
My original plan called for a peaked roof
like this (above), but I ended up thinking that it looked better flat -
with the railings.
To stiffen the whole thing up, I added
the white strip in back.
The groove created by the fame on the
skinny rooftop and the windows leaning up was the perfect place to put
railings. I then dry brushed it all and angled the tops of the
window pieces.
Here chalk weathering has been added.
So have the corbels. I used light green and yellow chalks to make
the metal part look old and then added a little rust here and there.
The stained glass really looks great
outside. I'll have to add a light in the conservatory to
illuminate it when it goes back inside.
With the roof removed you can see the
visitation going on. The wreaths of flowers were made from strip
wood and paper and ground foam with little flowers added. Well, I
hope you liked this part - it was fin to make - albeit a little bit
tedious! Now....
On to the fountain!